Fix: The Operation Failed as no Adapter is in the State Permissible for this Operation

If you receive an error that says “The operation failed. No adapter is in the state permissible for this operation,” it means that your Outlook is not able to connect to your Exchange server. This can be caused by a number of things, but the most common is that your Outlook is not set up correctly. You can fix this error by following the steps below.

What is the problem?

If you’re seeing the error message “The operation failed as no adapter is in the state permissible for this operation,” it means that there’s a problem with the network connection on your computer. This can be caused by a number of things, including loose cables, incorrect network settings, or a problem with the network adapter itself.

Section: How to fix it

There are a few things you can try to fix this problem:

First, check that all the cables on your computer are securely connected. If you’re using a wired connection, make sure the Ethernet cable is plugged in firmly to both your computer and the router. If you’re using a wireless connection, check that the WiFi antenna is plugged in securely and that the WiFi signal is strong.

Next, try changing your network settings. If you’re using a static IP address, try switching to a dynamic IP address, or vice versa. If you’re using a VPN or proxy server, try disconnecting from it.

Finally, if the problem persists, it may be due to a problem with the network adapter itself. In this case, you can try updating the driver for the network adapter or, if that doesn’t work, replacing the network adapter entirely.

READ  Fix: Unable to initialize OpenGL window

What are the possible causes?

There are several potential causes for this error:

1. The most common cause is that the Microsoft Exchange Information Store service is not running. This service must be running in order for the Exchange Management Console to connect to the Exchange server.

2. Another potential cause is that the Exchange server is not configured correctly. Specifically, the server may be configured to use a different port than the default port (TCP port 25).

3. Finally, it is possible that a firewall is blocking the connection to the Exchange server.

How to fix it?

If you see the error message “The Operation Failed as no Adapter is in the State Permissible for this Operation”, it means that you are trying to perform an action that is not allowed by the current state of the adapter. To fix this, you need to change the state of the adapter to one that allows the action you are trying to perform.

Fix: The Operation Failed as no Adapter is in the State Permissible for this Operation

Must Read

1. Check your server’s status. If it’s not running, start it up.
2. Ensure that your server has the latest updates installed.
3. Check the status of your network adapter. If it’s disabled, enable it.
4. Try to restart your computer.
5. If all else fails, contact your network administrator.

Conclusion

Thanks for taking the time to read my blog. I hope you found it helpful. If you have any questions or comments, please feel free to leave them below. I’ll do my best to answer them as quickly as possible.

Leave a Comment